Yamaha HTR-5440RDS Stereo Receiver User Manual


 
34
RECORDING A SOURCE
SILENT
PHONES VIDEO L AUDIO R
6CH INPUTINPUT MODE
INPUT
VOLUME
RDS MODE/FREQ
EON
PTY SEEK
MODE START
TUNING
MODE
PRESET
/TUNING
FM/AM
MEMORY
EDIT
BASS BALANCE SPEAKERS
PROGRAM
PRESET/TUNINGEFFECT A/B/C/D/E
AB
OFF
ON
STANDBY
/ON
DIGITAL
+
LR
TREBLE
+
MAN'L/AUTO FMAUTO/MAN'L MONO
SURROUND
DIGITAL
2
VIDEO AUX
1,4
Recording adjustments and other operations are performed
from the recording component. Refer to the instructions for
these components.
1 Set the volume at the
minimum level.
2 Select the source you want to record.
3 Begin recording by the recording component
connected to this unit.
4 Play the source and then turn up the volume to
confirm the input source.
Notes
Do a test recording before you start an actual recording.
When this unit is set in the standby mode, you cannot record
between other components connected to this unit.
The DSP program and the setting of VOLUME, BASS, TREBLE
and BALANCE have no effect on the material being recorded.
A source connected to the 6CH INPUT jacks of this unit cannot
be recorded.
A given input source is not output on the same REC OUT
channel. (For example, the signal input from VCR 1 IN is not
output on VCR 1 OUT.)
Check the copyright laws in your country to record from records,
CDs, radio, etc. Recording of copyrighted material may infringe
copyright laws.
If you play back a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
4
2
Remote control
INPUT
Front panel
or
VOLUME
Front panel
VOLUME
Front panel
or
Remote control
0106V420RDS31-34_EN 2/12/1, 1:36 PM34