Filter
Top Products
49
English
INTRODUCTION
PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
REMOTE CONTROL FEATURES
3 Press the numeric buttons to enter the four
digit manufacturer’s code for the component
to be used.
Refer to “LIST OF MANUFACTURER’S CODES”
at the end of this manual.
The TRANSMIT indicator flashes twice.
Notes
• If the manufacturer of your component has more than one
code, try each of them until you find the correct one.
• If you wait for more than 30 seconds during step 3, the setup
process is canceled. If this happens, start over from step 2.
Setting the manufacturer code
You can control other components by setting a
manufacturer code. Codes can be set for each of the 9
component controls.
The following table shows factory-set component
(Library: component category) and the manufacturer code
for each component control.
1 Press an input selector button or Å to select
the component you want to set up.
2 Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator flashes twice.
SLEEP
6CH INPUT
V
-
AUX
D
-
TV/CBL
AMP
VCR 1 VCR2/DVR
DVD
MD/CD-R TUNERCD
A
CODE SET
Component
control
(buttons)
CD
MD/CD-R
TUNER
DVD
D-TV/CBL
V-AUX
VCR 1
VCR 2/DVR
A
Component category
(Library)
CD
MD
TUNER
DVD
–
–
–
–
–
Manufacturer
YAMAHA
YAMAHA
YAMAHA
YAMAHA
–
–
–
–
–
TRANSMIT
STEREO
EFFECT
HALL
ENTER-
TAINMENT
TV
SPORTS
MONO
MOVIE
SELECT
EX/ES
MOVIE
THEATER 1
MOVIE
THEATER 2
/DTS
SUR.
ROCK
CONCERT
JAZZ CLUB
3421
5
90
ENTER
+10
678
Code
0005
0024
0003
0098
–
–
–
–
–
Clearing setup manufacturer
codes
■ Clearing setup manufacturer
code for the component control
1 Press an input selector button or Å to select
the component control for which you want to
clear the manufacturer code.
2 Press CODE SET by using a ballpoint pen or
similar object.
The TRANSMIT indicator flashes twice.
Note
• If you do not press any button within 30 seconds after step 2,
the clearing process is canceled. If this happens, start over from
step 1.
3 Enter the code number “0000”.
The TRANSMIT indicator flashes twice, and the
manufacturer code for the selected component is
cleared.
y
• You can clear all setup manufacturer codes at once by entering
the code number “9990”.
POWER
SLEEP
STANDBY
6CH INPUT
SYSTEM
V
-
AUX
D
-
TV/CBL
AMP
POWER POWER
AVTV
VCR 1 VCR2/DVR
DVD
MD/CD-R TUNERCD
A
CODE SET
TRANSMIT
0109V630_48-53_EN(GB) 1/11/02, 7:42 PM49