Filter
Top Products
Installation
1 SCSI ID number
Each of the SCSI devices connected to the computer is identified by its SCSI ID
number. You need to assign a number from “0” to “7” for each SCSI device.
Commonly, ID number “7” is reserved for the computer’s SCSI adapter card itself.
Therefore, the CRW8824S can actually be assigned an ID number from “0” to “6.”
The ID number is set by attaching/detaching the shunts on the ID Select jumper
switches according to the diagram shown below.
ID SELECT
PARITY
TERMINATO
R
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATO
R
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATO
R
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
124 124
ID SELECT
PARITY
TERMINATO
R
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATO
R
BLOCK SIZE
124
SCSI ID 0 SCSI ID 1 SCSI ID 2
SCSI ID 3 (Default)
SCSI ID 4 SCSI ID 5
SCSI ID 6 SCSI ID 7
The SCSI ID number for each device on the chain must be unique. Make sure the
CRW8824S drive’s SCSI ID number is not the same as that of any other device on the
chain. By factory default, the CRW8824S is assigned ID number “3” but this can be changed.
If the SCSI card supports SCAM and SCAM is turned “ON,” a different ID number
may be assigned if the SCSI ID number on the rear panel coincides with another
SCSI device.
10