E-25
GETTING STARTED
PLAYBACK
RECORDING
ADDITIONAL
INFORMATION
ENGLISH
....................................................... PLAYBACK FUNCTIONS
■ To check program data
1.
Press PROG during programming to display the
track number of the first track.
2.
Each time t or y is pressed, the programmed
track numbers and their order in the program can
be checked.
■ To correct program data
1.
Press t or y during programming to select the
track number to be corrected. The track number
blinks in the display.
2.
Press the numeric buttons to select a track to
replace the one displayed. The previously
programmed track is cleared from the memory
and the new one is displayed.
3.
After correction has been complete, press PROG.
■ To stop program play
Press a and the first programmed track number is
displayed. To resume program play again from the
beginning of the program press w.
■ To cancel the program play mode
Press CLEAR or a while this unit is in the stop mode.
Random Play
You can play all tracks in the disc in a random sequence.
1.
Load a disc and press RANDOM on the remote.
The RNDM indicator appears in the display and
random play begins.
2.
To stop the random play, press a (RANDOM on
the remote). The RNDM indicator in the display
turns off.
3.
To play a random sequence with two CDs, press
RANDOM on the remote after relay play of the
two CDs is set as described on page 22.
REPEAT RANDOM
CLEAR
A B
RANDOM
BA
RNDM
1 0:12
RNDM
L
dB
R
–60 –30 –I0 –6 –4 –2 –I0
OVER