Filter
Top Products
11
BASIC OPERATIONS See page 5 for location of button controls.
Standby Mode / Talk Time
The headset is automatically in Standby Mode when you remove it from the charger,
therefore, a single press of the multifunction button will put the headset into Talk
Time mode (you will hear a single beep). When the headset is in Standby Mode the
yellow indicator light on the headset will flash slowly, every 4-5 seconds. If the yellow
light is not flashing, turn the headset on (instructions below). Since standby time is
extensive (up to 100 hours on a full charge) it is usually not necessary to turn off the
headset to conserve battery power. However, if you wish to turn the headset off and
on, follow the steps below.
When the headset is in Talk Time mode, the yellow light on the headset will flash
faster, about once every second. To conserve Talk Time, be sure to put the headset
back into Standby Mode after a call by pressing the multifunction button for 1 second
(you will hear a single beep). The yellow flashing light will slow to once every 4-5 sec-
onds. It may take a few seconds for the light to change speeds.
Turning the Headset Off and On
• Off – Press and hold the multifunction button on the headset for about 3 seconds
until you hear 3 beeps that descend in tone (hold it up to your ear). The yellow light on
the headset will stop flashing. The headset is now off.
• On – Press and hold the multifunction button on the headset for about 3 seconds
until you hear 3 beeps that ascend in tone (hold it up to your ear). The yellow light on
the headset will begin flashing every 4-5 seconds. The headset is now on and you are
in Standby Mode.