Un-Mute The Microphone On The Headset
To un-mute the microphone, press and hold down the Increase Volume button for 4
seconds. You will hear a beep and the microphone will un-mute.
Switch From Headset To Handset While On A Call
1. Remove the handset from the phone’s cradle (if it is not already removed).
2. Firmly press the multifunction button on the headset for 1 second. You will see the
handset icon light up on the left front side of the base.
Note: If your B200 base is plugged into a headset port, you will need to press the line
or headset button to activate the call after you lift the handset.
3. Resume your conversation using the handset.
Switch From Handset To Headset While On A Call
Before switching, make sure the headset is in Standby Mode (page 14).
1. Put the headset on and position the microphone properly.
2. Activate the headset by pressing the multifunction button for 1 second. You will
hear a beep and the headset icon will light up on the right front side of the base.
3. If your B200 base is plugged into the phone’s headset port: You may place the
handset back in the cradle as soon as the headset is activated.
If your B200 base is plugged into the phone’s handset port: Do not place the hand
set back in the cradle until after the call has ended.
1716
Answer A Call / End A Call
Answer A Call
Before answering, make sure the headset is in Standby Mode (page 14).
1. If the headset is not on your head, put it on and position the microphone properly.
2. Activate the headset*: Firmly press the multifunction button on the headset for 1
second, then release. You will see the headset icon light up on the right front side of
the base (it may take a few seconds for the headset icon to light up).
* If the headset icon is already showing on the front of the base, then the headset is
already active and you may simply activate the phone as usual (step 3).
3. Remove handset from cradle or press the line or headset button. You will be con-
nected to the call.
End the Call
Place the phone’s handset back in the cradle or press the phone’s line or headset but-
ton to disconnect the call on your phone.
Adjust Speaker Volume
To adjust the volume in your earpiece, press the increase or decrease volume button
for 1 second, then release. Repeat until volume is at desired level. You will hear a sin-
gle beep each time you press the button.
Mute The Microphone On The Headset
To mute the microphone, press and hold down the Increase Volume button for 4 sec-
onds. You will hear a beep and the microphone will mute. A beep will be heard period-
ically indicating that the microphone is in Mute Mode. This will not be heard on the
other end of the call.