VXI B200 Headphones User Manual


 
1514
1. Put the headset on and position the microphone properly.
2. Activate the headset*: Firmly press and release the multifunction button on the
headset for 1 second. You will hear a beep. The headset icon will light up on
the right side of the base indicating that the headset is active (it may take a few
seconds before the headset icon lights up). Activate your phone by removing the
handset from the cradle or by pressing the line or headset button. If the dial tone is
too loud when you activate your phone, you can press the volume decrease button 1-3 times
before activating the headset.
3. Dial as usual.
* If the headset icon is already showing on the front of the base, then the headset is
already active and you may simply activate the phone and dial as usual.
End the Call
Place the handset back in cradle, or press the line or headset button on the phone to
end the call.
Adjust the Microphone Volume
The Microphone Volume Adjustment is located on the
bottom of the B200 base (see photo). If the person on
the other end of the call is having trouble hearing you,
position the base as shown and turn the knob clockwise
to increase the volume. If your voice is too loud, turn
the knob counterclockwise to decrease volume.
Microphone Volume Adjustment
BASIC OPERATIONS
See page 6 for location of button controls.
Standby Mode
The headset is automatically in standby mode when you remove it from the base;
therefore, a single press of the multifunction button will activate the headset. After
removing the headset from the base, a yellow flashing light on the headset indicates
that Standby Mode is active (you may need to wait 5 seconds to see it). If the yellow
light is not flashing, turn the headset on (instructions below).
Since standby time is extensive and the headset continues to charge any time it is
stored in the base, it is usually not necessary to turn off the headset to conserve bat-
tery power. However, if you wish to turn the headset off and on, follow these steps.
Turning the Headset Off and On
• Off (Standby Mode not active) – Press and hold the multifunction button on the
headset for about 3 seconds until you hear 3 beeps that descend in tone. The yellow
light on the headset will stop flashing. The headset is now off and you are no longer in
Standby Mode.
• On (Standby Mode active) – Press and hold the multifunction button on the headset
for about 3 seconds until you hear 3 beeps that ascend in tone. The yellow light on the
headset will flash every few seconds. The headset is now on and you are in Standby
Mode.
Make A Call / End A Call
Make A Call
Before you begin, make sure the headset is in Standby Mode (see above).