Filter
Top Products
9
In Preset mode (i.e., when the PRESET LED is lit), you can recall preset programs
that contain sounds and effect settings that are typical of each amp model.
[GAIN] control
This adjusts the pre-amp gain of the selected amp model.
[VOLUME] control
This adjusts the volume of the selected amp model.
[TREBLE], [MIDDLE], [BASS] controls
These adjust the tone for the high, mid, and low-frequency ranges. The change pro-
duced by each control will differ depending on the amp model that you’ve selected.
[REVERB] control
This adjusts the mix amount for the reverb.
[MASTER] volume
This adjusts the volume that is output from the pre-amp to the Valve Reactor power
amp. This setting will change the amount of the Valve Reactor’s distortion.
NOTE: The [MASTER] volume setting is not programmed.
NOTE: The amount of Valve Reactor distortion is also affected by the GAIN
control. For some settings, there will be almost no distortion.
3. Effect section
Here you can make settings for effects and noise reduction. For details on each effect,
refer to “Explanation of the amps and effects” (p.18).
[EFFECTS] selector
This selects the effect type. You can use the [TAP] switch and [EDIT] knob to adjust
the parameters of each effect. When you switch the effect type, the parameter set-
tings of the effect will be initialized, and Effect Bypass will be disabled.
[EDIT] knob
This adjusts the parameters of each effect. The knob can adjust three different param-
eters when used in conjunction with the [TAP] or [BYPASS] switches as described
below (when the BYPASS LED is unlit).
- EDIT 1: Turn the [EDIT] knob (without holding down a switch).
- EDIT 2: Turn the [EDIT] knob while holding down the [TAP] switch.
- EDIT 3: Turn the [EDIT] knob while holding down the [BYPASS] switch.
When the BYPASS LED is lit (i.e., when the effect is bypassed), you can adjust the
sensitivity of the noise reduction by holding down the [TAP] switch and turning the
[EDIT] knob.
NOTE: You can’t adjust effect parameters while the BYPASS LED is lit.