11
[CHANNEL] switches, LEDs
Use these to select channels. The LED of the selected channel will be lit. To save a
new program, hold down the desired [CHANNEL] switch for one second or longer.
5. Power switch
[POWER] switch
When the power is on, the indicator located above the switch will be lit.
B. Rear panel
VT15/VT30
1
2
3
The illustration shows the VT15.
1. AC power connector
This is where you connect the included power cord.
2. FOOT SW (foot switch) jack
You can connect an optional foot switch (VOX VFS5: sold separately) here and use it
to switch programs while you perform.
NOTE: You must connect or disconnect the foot switch while the power is
off. Malfunctions or damage may occur if you connect or disconnect the foot
switch while the power is on.
3. POWER LEVEL control
This adjusts the output wattage of the power amp.
VT15: less than 0.2W – 15W
VT30: less than 0.2W – 30W
NOTE: The power level setting is not saved in the program.
This allows you to output at a range of volume levels without impairing the fat and
warm sound (distinctive of classic tube amps) that is produced when you raise the
drive of the Valvetronix amp’s power stage. Even when you’re practicing in a small
room, you can play without damaging the listener’s eardrums or compromising the
great tone.