Filter
Top Products
AG1
AG1
AT2
AT2
AT3
AT3
AT1
AT1
C05
C05
9
1
STEP
•
NOTE: It is recommended that all
bolts in Steps 1 thru 4 are loosely
fastened. Tighten all hardware at
the conclusion of Step 4
• With the flat side down, place the left
foot support (AT2) up against the main
floor support (AT1), aligning the three
holes along bottom of both pieces. Place
three bolts (M10x72) and three flat washers
(10.2x22x2) through left foot support and
main floor support. Take right foot support
(AT3) and slide onto bolts sticking out
other side of main floor support (AT1).
Place a flat washer (10.2x22x2) on each
bolt, and partially thread one nylon nut
(M10) on each bolt. Do not place bolts
through other remaining holes until next step!
• Stand the upright frame (AG1), placing
the end with four holes in the broad side,
into the remaining slot between the left
and right foot supports. Make sure the
rollers on the upright are facing the seat
support. Use four bolts (M10x72), eight
flat washers (10.2x22x2), and four nylon
nuts (M10) to secure the upright.
• Attach a bracket (C05) to each side of
the upright frame (AG1) with two bolts
(M5x10), two lock washers (5.1x9.3x1.3),
and two flat washers (5.3x10x1.0).
ORANGE BAG