Filter
Top Products
16
AT4
EC8
AG3
AB1
AE1
B14
AT1
T17
8
STEP
• Slide the thigh support post (AT4) into
the seat support opening (AT1). Thread
pull pin (T17) into hole on the front of the
seat support (AT1) until it latches into
place.
• Mount the seat onto the seat support
using six bolts (M10x25).
• Attach the two bar storage snap hooks
(B14) to the side of the weight stack tower
(AB1) with four bolts (M5x15), four spring
washers (5.1x9.3x1.3), and four flat
washers (5.3x10x1).
• Attach the instructional placard (AG3) to
the front of the upright frame by sliding a
bolt (M10x75) and a flat washer
(10.2x22x2) through the four holes.
Fasten with another flat washer
(10.2x22x2) and a nut (M10).
• Attach row handle (AE1) to the karabiner
at the center of the upright frame. Attach
the aluminum bar (EC8) to either the dual
karabiners at the top or to the snap hooks
(B14). The same can be done with the
two co-molded handles.
YELLOW BAG