Filter
Top Products
13
A
C
J
D
F
G
H
I
K
E
B
F17
AF2
AF1
5
STEP
• Remove pulley A from the left overhead
pulley bracket (AF2) and guide one end of
cable #1 (F17) through housing on the
bracket. Reinstall pulley, making sure
cable is between pulley and small roller in
front of the bracket. Guide the cable
along the overhead arm, through pulleys
B, C, and D. Remove pulley E from weight
stack pulley bracket, reinstalling after guiding
the cable through. Bring cable back up
weight stack and around pulleys F, G, and
H. Remove pulley I from the right side
overhead pulley bracket and guide end of
cable through housing. Reinstall the pulley
with cable in between it and small roller.
• Take the floating tri-pulley bracket
assembly (AF1) and hang the upper left (J)
and right (K) pulleys from the cable (F17)
you just installed. In between pulleys B
and C on the overhead lat arm, pull the
cable down and wrap around pulley J on
the assembly. Repeat on the other side by
wrapping the cable around pulley K, after
pulling down between pulleys G and H.
See diagram for clarification.
CABLE #1