Filter
Top Products
VPM-62289 USER MANUAL10
Step2.
a) Place the 5.25” IDE device in the bottom enclosure cover. Align
the 5.25” IDE device mounting holes with the mounting holes on
the bottom cover and secure with four screws (two on each side).
c) Attach the 4-pin power cable from the rear panel of the bottom
cover to the 4-pin connector on the back of the 5.25” device.
b) Attach the IDE 40-pin data cable from the rear panel of the
bottom cover to the 40-pin connector on the back of the 5.25”
device. To ensure pin-1 to pin-1 connection, orient the cable so the
colored stripe edge is closest to the power connector.
One 5.25” Device
40-pin IDE Data
Connectors
4-pin Power
Connectors
4-pin Power Cable
on the rear panel
of the bottom cover
IDE 40-pin Data Cable
on the rear panel
of the bottom cover
Bottom
Cover
5.25-inch
IDE Device
Mounting
Screws
Mounting
Screws