Vincent Audio SV-234 Stereo Amplifier User Manual


 
4422
Vincent
SSyymmppttoomm PPoossssiibbllee CCaauussee CCoouunntteerrmmeeaassuurree
Front panel display
does not work
It has been switched off before using
"DIMMER" (7).
Press the button "DIMMER" (7) one more time.
Poor sound quality
The cable connections are not tight, the
connectors are dirty or a cable is defective.
A record player has been connected to a high
level input without using a phono preamplifier.
An audio source with standard line level
output is connected to the amplifier direct
input "LINE5" (11).
Check the cables and cable connections.
Interconnect a phono preamplifier.
Use line level audio sources only at the
inputs "LINE1"..."LINE4".
The remote control
cannot perform any
functions
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated from
a position too far to one side.
The unit is not switched on.
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear,
within a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.
Humming low
frequency noise is
audible, even as
no audio source is
playing back
See section "Net frequency noise" in the chapter "Tips".
Frequency response: 20 Hz - 20 kHz ±0,5 dB
Nominal Output Power at 8: 200 W
Nominal Output Power at 4: 289 W
Input sensitivity: 400 mV
Total Harmonic Distortion: < 0.1%
Signal to Noise Ratio: >90 dB
Input Impedance: 47 k
AC power connection type: 220-240V/50Hz
Inputs: 4x RCA stereo, 1x RCA Main Input stereo,
1x XLR stereo, 1x Power Control (3,5 mm jack)
Outputs: Speaker connectors accepting 4 speakers,
1x PRE stereo RCA, 1x REC stereo RCA,
2x Power Control (3,5 mm jack)
Dimensions: 430 x 142 x 450 mm
Weight: 20 kg
Colour: silver / black
TTEECCHHNNIICCAALL SSPPEECCIIFFIICCAATTIIOONNSS