Filter
Top Products
Vincent
3333
This stereo amplifier is equipped with a main amplifier input ("LINE5"), also known as "unity gain input".
Input signals to this bypass the internal preamplifier stage and are treated as preamplifier output signals.
That is why this amplifier can accept the output signals of a preamplifier or the front channel preamplifier
outputs of a home cinema system (AV receiver or AV preamplifier). Volume control as well as Balance and
Muting can not be achieved at the SV-234 when using the input "LINE5". These functions must be opera-
ted at the device connected to this input.
If the input "LINE5" has been selected, the amplifier SV-234 acts like a stereo power amplifier. If you want
the amplifier SV-234 to automatically switch on/off every time the HiFi component connected to "LINE5"
is switched on/off, the power control cable connections subsequently described must be applied.
Please leave the input connector "LINE5" unused if you do not wish to use the amplifier SV-234 just as
a power amplifier.
Many AV-Systems consist of a multitude of individual components. To avoid the necessity of switching them
on and off before and after every use, many manufacturers have equipped their devices with what is
known as "POWER CONTROL" circuit or "TRIGGER". This kind of remote-controlled standby circuit is
used primarily for preamplifier and power amplifiers. To employ these functions, direct or indirect cable
connections must be made between the preamplifier (or integrated amplifier) and all the devices which
support this function. The “POWER CONTROL” function operates in such a way that each switching on
or off of one device in the system (usually the preamplifier) automatically brings about the switching on or
off of all the connected devices which support this function. Please keep in mind that all devices which
respond to the power control are not disconnected from the mains network when switched off. They are
set to a standby state instead. For connecting cables, two-core cables with 3.5 mm jack plugs (mono) are
used. For each connection between two devices one of those cables is needed.
CCOONNNNEECCTTIIOONN OOFF AA SSTTEERREEOO PPRREEAAMMPPLLIIFFIIEERR OORR TTHHEE
FFRROONNTT CCHHAANNNNEELLSS OOFF AA MMUULLTTII--CCHHAANNNNEELL SSYYSSTTEEMM
CCOONNNNEECCTTIIOONNSS FFOORR TTHHEE SSTTAANNDDBBYY CCOONNTTRROOLL
((PPOOWWEERR CCOONNTTRROOLL))
SV-234
Stereo preamplifier
OUTPUT
RCA connection
SV-234
e.g. AV preamplifier
ANALOG
AUDIO OUTPUT
RCA connection
PRE