Filter
Top Products
3388
Vincent
OOppeerraattiioonn BBuuttttoonn((ss)) DDeessccrriippttiioonn
Switch on and off
PPOOWWEERR ((55))
The amplifier is switched on and off using this button at the front panel.
When switched off the device is not internally separated from the AC
power and reacts to a signal at the input "POWER CONTROL INPUT"
(15). That is why it is not possible to switch off the amplifier as long as
a 12V trigger signal is present at this input.
WELCOME
As a precaution, after switching on, the volume setting should
be reduced.
Individually activate or
deactivate speaker
outputs A and B
SSPPEEAAKKEERR
AA//BB ((11))
To play back stero music via loudspeakers at least one pair of them
must be attached to the amplifier (a practical choice would be
connectors "A"). The output you use must be activated using the
corresponding button "SPEAKER" (LED illuminated). Only if a second
pair of speakers is used, it is necessary to activate the second speaker
output "B".
Select an input
IInnppuutt SSeelleeccttoorr
bbuuttttoonnss
((1100))((1111))((1122))
A short touch on the button for the desired input channel
("LINE1"..."LINE5" or "BALANCED") changes to the playback of the
audio source connected there. The front panel as well as the remote
control carry those buttons. The name of the currently selected input
channel appears in the display.
LINE2 → LINE2 -45dB
Before switching over the input channel, the volume should be turned
down as a precaution!
Change the volume
LLEEVVEELL
//
((33))((1199))
Hold down the button "LEVEL
" to turn the volume up. Use "LEVEL
" to
turn it down. This can be done on the remote control as well as at the
amplifier front panel. The display (2) shows the momentarily selected
volume value. The minimum volume value is -99dB, the maximum volume
appears at latest with 00dB, for most speakers much below this value.
LINE2 -99dB
←
...
→
LINE2 00dB
The volume value can not be changed if the input "LINE5 MAIN IN"
has been selected. In this case the display shows "MAX". The volume
setting dors never influence the signal at the output "REC OUTPUT" (13).
Mute the speakers and
the preamplifier output
MMUUTTEE ((1177))
The MUTE function can only be operated with the remote control.
It switches off the loudspeakers, the preamplifier output "PRE OUTPUT"
(14) and the recording output "REC OUTPUT" (13). Pressing it again
restores the volume to its original setting. As long as the amplifier is
muted, the display shows "MUTING".
MUTING
←
...
→
MUTE OFF
OOPPEERRAATTIINNGG TTHHEE AAPPPPLLIIAANNCCEE