Filter
Top Products
To attach the speaker to the wall-mounting device:
ATTENTION:
As both WEBERN or BERG are symmetrical in driver orientation (having not top or
bottom) selecting an orientation position for the speakers so that the tweeters face in
or out, as well as up or down, can be done to suit the nature of each installation. It is
recommended that experimentation take place to determine which orientation of the
tweeters results in optimal performance.
1. Please put on the enclosed gloves to avoid fingerprints.
2. Insert the lower conical tipped bolt inside the wall-mounting bracket completely
with the hexa-gonal tool (Allen wrench/key). [For center posi-tioning simply start with
whichever side is most convenient.]
ATTENTION:
The accessories box includes two plastic sockets, which you can put on the conical
point of the bolts to avoid scratching the inlays. Once the preferred position is found,
they can be removed.
3. After you have chosen a position, place the speaker in away that the lower bolt fits
into the chosen conically milled point on the cabinet inlay.
4. Press the speaker against the rubber-pad and attach the speaker to the bracket
by tightening completely the upper conical tipped bolt with the hexagonal tool (Allen
wrench/ key). Please make sure that you use the same conically milled point on both,
lower and upper, inlays.
ATTENTION:
For safety reasons it is recommended that all connection bolts be tightened every six
months.
B. Free-standing application:
Connecting the speakers to the aluminium stands (please see drawing):
ATTENTION:
Usually, you want the tweeters to look in two different directions. In this case, you
have to act as follows:
1. Please put on the enclosed gloves to avoid fingerprints.
2. Put your pair of speakers in front of you in a way that the tweeters are to the inside.
3. Pull out the inlay of each speaker. Since they are attached with magnets, they
simply pull off.
4. Put the spacer bars on the two speakers, so that the holes (two in each bar and two
in each speaker) for the two bolts match.