Filter
Top Products
7
REAR PANEL SECTION
25
28
24 27 32 33 31 30 29 26 25 24 27
24
PHONO 1,2 [RCA PIN JACK]
Connect turntables equipped with MM (Moving
Magnet type) cartridge. The signal from the
turntable is fed to the PGM channels when Phono
input is selected.
25
LINE 1,2,3,4 [RCA PIN JACK]
Connect the equipment with line level output (-10dB
or 0dB), such as CD players, tape decks, DATs,
MDs etc. The signal from line level equipment is
fed to the PGM channels when Line input is
selected.
26
AUX IN (LINE 5, PHONO 3) [RCA PIN JACK]
Input jack for turntable and line level equipment.
The signal from these jacks are fed to AUX input
channel.
27
GND (Ground Terminal)
Connect the ground lead from the turntable. Failure
to connect a ground lead produces noise on Phono
input signal.
28
PA OUT (Balanced Output) [XLR MALE, 2 PIN HOT]
Main output jacks. Connect to the input of the
power amplifier or the master console with XLR 3
pin cable.
29
PA OUT LEVEL (Balanced Output Level Select Switch) [-10dB/0dB]
Used to select the output level of the PA OUT from
-10dB or 0dB. Please select the level according to
the input sensitivity of the power amplifier or the
master console.
30
LINE OUT (Unbalanced Output) [1/4" INCH PHONE JACK]
Unbalanced LINE output. Connect to the input of
the power amplifier or the master console with 1/4"
phone cable. PA OUT LEVEL (#29) does not effect
this output.
31
BOOTH OUT (Output for Monitor System) [1/4" INCH PHONE JACK]
Connect to the input of the power amplifier of the
DJ booth monitor system.
32
POWER (Power Switch)
Lights up when the power is on.
33
AC IN
Connect the AC-12A AC Adapter. (12V AC, 1000mA)
CAUTION
When the line level equipment is connected to
LINE 5 input jack, the input signal from PHONO
3 is disconnected and only the signal from line
level equipment is fed to AUX input. Please
disconnect LINE 5 when turntable is used.