Filter
Top Products
7
HI CUT (Fader type cut switch HI)
When this volume is set to bottom position, high
frequency range is cut of completely regardless of
the position of the HI level control. The HI level
control knob becomes active when this volume is set
to maximum top position.
8
MID CUT (Fader type cut switch MID)
When this volume is set to bottom position, mid
frequency range is cut of completely regardless of
the position of the MID level control. The MID level
control knob becomes active when this volume is set
to maximum top position.
9
LOW CUT (Fader type cut switch LOW)
When this volume is set to bottom position, low
frequency range is cut of completely regardless of
the position of the LOW level control. The LOW
level control knob becomes active when this volume
is set to maximum top position.
10
INPUT FADER
Used to adjust the input level of each program. Please
replace with IF-25 when it is worn out, or with the
optional rotary fader unit, RF-25, for house applications.
5
MASTER SECTION
11
LED LEVEL METER
The bar graph level meters indicate the master
output level L channel and R channel or input
level of each program program 1 and 2 .
12
METER SELECT
When this switch is set to MASTER, the bar-graph
meter indicates the master output level L channel
and R channel . When it is set to PGM, the left
meter shows the input level of PGM1 and the right
meter shows the input level of PGM2.
13
AUX (AUX level volume)
Used to adjust the Input level of AUX IN.
15
16
12
13
14
11
HOW TO REPLACE THE INPUT FADER
Remove four screws, which hold the fader unit panel.
Remove the input fader unit, IF-25.
Carefully remove the multi-cable connector from
the fader unit.
Insert the connector to the new fader unit.
Place the fader unit to proper position and fix it
with four screws.
+
+
+
+
Remove
four screws.
Remove the multi-cable
connector from fader unit.
14
MASTER (MASTER level volume)
Adjusts the output level of LINE OUT and PA
OUT.
15
BOOTH OUT
Adjusts the output level of BOOTH OUT.
16
CROSS FADER
The signal from PGM1 is output when the cross
fader is set to the left side. The signal from PGM2 is
heard when the cross fader is set to the right side.
When the cross fader is set at centre position, both
programs will be mixed and output at the same time.
Please replace it with the CF-R when it is worn out.