Filter
Top Products
- 23 -
1. DATE & TIME: set system clock/calendar
When selects “1.DATE & TIME” in SET
command menu, the screen as right will be
shown on PDT’s LCD and let you set the
system date and time of Real Time Clock chip
(RTC). The system date and time can be retrieved in application and
used as time stamp for data collection.
The second line shows the current date in the format YYYY/MM/DD
(year/month/day). If you want to reset the system date to January 1,
1997, then enter[1][9][9][7],[0][1],[0][1]. Or press [ENT] key to skip
the system date setting.
The third line shows the current time. The way to set system time is
similar to set system date described above. The format of system time
is expressed in 24 hour of HH:MM:SS (hour:minute:second).
2. SCANNER: set reading mode of built-in
The system software of PDT decodes all major bar code symboloies
including Code 39, Code 128, Codabar, Code 93, I25, EAN, UPC,
China Post code, etc. Use the [
àà
] key to toggle among selection in
each category, then press [ENT] to confirm.
SCANNER Enable / disable bar code decoding.
PEN SCAN KEY When pen scanner is used on PT600, user can
setup whether pressing trigger key to enable pen
scanner. If ENABLE is selected, user must press
and hold down trigger to scan barcode label. If
DISABLE is selected, user can directly scan
barcode label without pressing trigger key.
Enable / Disable
3. DISPLAY: Enable/disable power-on logo display
ENABLE Show system logo when power-on.
DISABLE Do not show system logo when power-on.
DATE-TIME SETUP
1998/01/01
08:00:00