Filter
Top Products
- 17 -
2.4 Recharging the Battery Pack
When the PDT shows “Main battery low” message or sign , the battery
pack in PDT needs to be recharged. There are two ways to charge the
battery: regular and quick charging as shown below.
AC to 9V DC
Transformer
Outer shell
Inner shell
Positive(+)
Negative(-)
Regular Charging
Plug one end of an AC-9VDC power adapter into the DC-jack of RS232
cable and the other end into a wall outlet. The battery pack will be fully
recharged after 14~16 hours.
Quick Charging with PT016
AC to 12V DC
Transformer
Outer shell
Inner shell
Positive(+)
Negative(-)
Charge
Battery
Connect power adapter to PT016 and insert PDT into the chamber of
PT016. The battery of PDT can be fully charged in about 2.5 hours and
the status of battery charging is indicated by the LED on the front panel
of PT016.(please refer to PT016 manual for detail information. )