Filter
Top Products
- 22 -
TYP This command dumps the content of a
file on the PDT's LCD. The content of
the file will be displayed 128 (16
character x 8 line) characters at a time.
Press any key to show the next page or
hit [CMD] then [ALPHA] keys to return to User mode
prompt. If you try to display a program or binary file, you may
only see unintelligible characters.
CPY This command allows users to make copy of data from a source
device to a destination device. The source device may be a file,
COM(serial input), CON(keyboard), and the destination device
may be a file, COM(serial output), CON(LCD display).
Source Dest. Function
file1 file2 copy file1 to file2
file1 COM output content of file1 to serial port
file1 CON output content of file1 to LCD
COM file2 input data from serial port and store in file2
CON file2 input data from keyboard and store in file2,
press [CMD] and then [ALPHA] key to end
the data input
SET This command allows users to set system date and time, assign
laser or pen scanning feature and enable to display power-on
logo (see next section).
3.3 Configure the Terminal in SET command
There are three categories of general system
configuration available in SET command. Select
the corresponded number, 1-3, to set system
date/time, assign scanning feature and enable
power-on Logo display. Hit [CMD] then [ALPHA] keys to return to User
mode prompt.
< TYPE FILE >
SCAN.DAT
<SYSTEM SETUP>
1.DATE & TIME
2.SCANNER
3.DISPLAY