Filter
Top Products
- 19 -
Chapter 3 Operation
The system of PDT may operate in various modes for different purposes.
The figure below shows the operating flow of the PDT.
press
press
press and hold down
enter
program
then press
press
and keys
CMD
EXIT
ENTER
CMD
<− <−
then press
PWR
PWR
name
(for two
press
2
press
1
seconds)
OFF
SUPERVISOR
mode
1.SUPERVISOR
2.WARM START
APPLICATION
mode
3.COLD START
<<START MENU>>
MEM 512KB
>
PT600 V1.00
3.COM 4.DIR
5.ERA 6.TYP
7.CPY 8.SET
1.RUN 2.TER
RUN
command
USER mode
Alphathen
System configurations are categorized in two groups, users can select
“8.SET” command in User mode to set general system configurations or
enter Supervisor mode to set advanced system configurations. The
Supervisor mode is also protected with password checking to prevent
unauthorized personnel from changing the system configuration.
(for PT600 detail information please refer to PT600 Technical Binder)
3.1 Ready Mode
The PDT performs a Power-On-Test and Warm-Start when it is switched
on. After the Warm Start, the system enters Ready mode and shows the
Ready mode prompt.