Filter
Top Products
user manual
MILAN Mi0
MILAN Mi0 user manual
Page 7
Getting Started
MIC GAIN
POWER
ON
BASS TREBLE
MIC IN MIX OUTGROUND LIFT LINE IN
LINE LEVELON
MAXMIN +-+- MAXMIN
LIMIT
1. Turn the Mic Gain and Line Level controls fully anticlockwise (MIN).
2. Set the Bass and Treble tone controls to their centre position (no boost or cut).
3. Connect your signal sources (mixing console, keyboard, microphone, acoustic guitar) to
the appropriate input connector.
4. Switch on the mixer or other source and make sure the output faders or master output
level controls are turned fully down.
5. Ensure that the mains voltage requirement of you model as indicated by the voltage label
(230v or 120v) matches your local AC mains supply. Connect the AC mains cable to the
Milan loudspeaker and turn on the mains switch. The green POWER LED will illuminate
to indicate that mains power is connected.
6. Increase the output level of the signal source to a normal operating level.
7. Slowly turn up the Milan loudspeaker’s level control(s) until a suitable volume level is
reached. The SIG/LIMIT LED illuminates green to indicate signal present and flashes red
when limiting. It is normal for the SIG/LIMIT LED to flash occasionally, but excessive or
prolonged illumination indicates that the input signal is too high or additional speakers
are required.