Filter
Top Products
Connecting the Receiver
Do not connect the receiver to the mains power supply until you have connected it properly to
all devices and to the aerial. Otherwise the receiver may be damaged.
The wire mesh and the inner wire of the coaxial cable carry electrical current during
operation.
Fitting the Aerial Cable
The receiver is connected to your satellite aerial via a coaxial cable and the F-connector.
For fitting the F-connector onto the coaxial cable you need wire strippers and wire-cutting pliers.
Cut 8 mm of coaxial cable at each end down to the inner core.
Carefully strip 10 mm of the outer insulation off, so that the wire mesh is free.
Peel the wire mesh back over the outer insulation, so that it is not touching the inner wire.
Remove the inner insulation up to 2 mm in front of the wire mesh.
13