Filter
Top Products
Operation of Bodypack Transmitter
A. Battery Installation:
1. Switch the transmitter off before inserting batteries.
2. Slide the battery cover off.
3. Insert 2 disposable batteries (1.5V AA) or 2 rechargeable batteries (1.2V AA).
4. Observe correct polarity when inserting batteries.
5. Slide the battery cover back to its original position.
B. Turning unit on:
1. Switch the power to ON position
2. The RED LED will light and the LCD will display "On".
Battery status and channel will then appear.
If no other operation is performed, LCD light will go off automatically in 5
seconds.
C. Channel/Frequency Settings:
1. Press and hold the SET button for approximately 2 seconds until the channel
number flashes.
2. Release the SET button and the current channel will keep flashing
3. Press the UP or DOWN buttons to select a different channel.
4. When the desired channel is displayed press the SET button again. The
display will stop flashing and stay on the channel selected.
5. Press and hold the UP or DOWN buttons to display the frequency associated
with the channel number selected.
D. Meanings of LCD appearance:
1. Batteries fully charged and channel 08 selected.
2. One bar displayed indicates low-battery. The batteries need to
be changed or rechargeable batteries need to be recharged.
3. No bars displayed indicates the batteries are exhausted and
after flashing three times, the power will automatically shut off.
19