Filter
Top Products
11
D. In/Out Jacks (see page 7)
1. The system contains Line In, Line Out, and Mic in jacks for connecting external
audio devices.
2. Line In (E1): Pg.7 RCA jacks to connect external audio sources, such as CD/
MP3 players or iPods. The volume of the Line In is controlled solely by the
Master (D1).
3. Line Out (E2): RCA jacks to send the signal to other audio devices, such as
recorders, mixers, or power amps.
4. Mic In (E3): XLR or 1/4” (6.3mm) phone jack for wired microphones. Volume
of this input is controlled by Mic In (D4) and the Master (D1).
E. Speaker Out: (see page 7)
1. Used to connect to an external unpowered speaker (8Ω Min.)
F. Digital Echo System (see page 8)
1. Turn the power switch (H1-1) Pg.8 clockwise to turn on the echo system. Then
use this control to adjust the level of echo in the mix .
2. Adjust the repeat button (H1-2) to select the number of repeats desired.
Adjust the delay button to select the delay time.
3. Mic input jacks (H1-6 and H1-7) are provided for connecting wired Mics. Mic
volume is controlled by H1-4 and H1-5 plus the Master (D-1).
G. Audio Link Transmitter (see page 8)
This module transmits the entire audio mix from one Traveler to another Traveler
equiped with a wireless Mic/Audio Link Receiver.
1. Turn the power switch (H2-7) clockwise to turn on the transmitter.
2. The LCD display (H2-1) will show “On” and the channel in use when the unit
was last turned off.
3. To select a different channel, press the set button (H2-5) and the channel will
flash in the LCD display. Press the up or down button (H2-6) to select the
transmit channel, and then press the set button again to enter the setting. The
LCD will then automatically display the selected channel. To display the
frequency of the selected channel press and hold either the up or down button.
4. Turn the volume control (H2-7) to adjust the audio transmit level. Use this
control in conjunction with the volume controls on the receiving Traveler.