Filter
Top Products
OPERATION
29
Other Function
Sleep Timer Setting
You can set the DVD/CD Receiver to turn off automati-
cally at a specified time.
11
Press SLEEP to set the desired sleep time.
The SLEEP indicator and sleep time appears in the dis-
play window.
22
Each time you press SLEEP the setting changes
in the following order.
SLEEP 90 →80 → 70 →60→ 50 → 40 →30 → 20 →10 →
OFF
Note
You can check the time remaining before the
DVD/CD receiver turns off.
Press SLEEP.The remaining time appears in the
display window.
Dimmer
This function will change the brightness of the display
window on the front panel during power-on status.
Press the DIMMER repeatedly.
Mute
Press MUTE to mute your unit.
You can mute your unit in order, for example, to answer
the telephone, “MUTE” indicator flashes in the display
window.
Using Headphone Jack
Connect a stereo headphone plug ( 3.5mm) into the
PHONES connector.
The speakers are automatically disconnected when you
plug in a headphone (not supplied).
Selecting input source
You can use VCRs or other units connected to the AV1,
AV2 connectors, EURO SCART, Coaxial connector or
Optical connector. Refer to the owner’s manual supplied
with the unit for further information on the operation.
Press AUX repeatedly on the remote control to
select the desired input source.
Each time you press this button, the mode of the func-
tion changes in the following sequence:
AV 1: for selecting the analog signal from AV1 AUDIO IN
(L/R) & VIDEO IN Connectors.
AV 1 OPT: for selecting the optical digital signal from AV1
VIDEO IN & OPTICAL IN Connector.
AV 1 COAX: for selecting the coaxial digital signal from AV1
VIDEO IN & COAXIAL IN Connector.
AV 2: for selecting the analog signal from AV2 AUDIO IN
(L/R) & VIDEO IN Connectors.
AV 2 OPT: for selecting the optical digital signal from AV2
VIDEO IN & OPTICAL IN Connector.
AV 2 COAX: for selecting the coaxial digital signal from
AV2 VIDEO IN & COAXIAL IN Connector.
TV-AUDIO: for selecting the TV audio signal from the TV that
is connected by the SCART cable.
Notes
There is only one set of OPTICAL and COAXIAL
input connectors.They are common for AV1 and AV2.
The Optical input function is available only when the
other unit’s Sampling Frequency is 32 ~ 96kHz.
You can also select the input source by pressing
FUNC./PLAY button on the front panel.
Press and hold down this button about 3 seconds,
then press repeatedly to select input source.
Reception of RDS (Radio Data System)
Stations
RDS (Radio Data System) is a system gradually being
introduced on FM in many countries, where by an
inaudible stream of data is transmitted in addition to the
normal radio signal. This data contains various informa-
tion including station/ transmitter identification, traffic
information and a list of alternative frequencies for the
radio station being received.
11
Press FM/AM to select FM.
22
Select a desired station by pressing the
PRESET
+
or
-
.
When the RDS transmission is received, the display
shows the program service name (PS) after RDS indicator
appears.
33
Press RDS to recall the frequency.
Notes
RDS is only available for FM reception.
The PS (PROGRAM SERVICE) NAME is displayed automat-
ically when a RDS station is received.