Filter
Top Products
28
Operation with Radio
Presetting the radio stations
You can preset 50 stations for FM and AM (MW). Before
tuning, make sure that you have turned down the vol-
ume.
11
Press FM/AM on the remote control until FM or
AM (MW) appears in the display window.
22
And then every time you press FM/AM, FM and
AM (MW) changes alternately.
33
Press and hold TUNING - or + on the front panel
for about two seconds until the frequency
indication starts to change, then release.
Scanning stops when the DVD/CD Receiver tunes in a
station. “TUNED”and “STEREO” (for stereo program)
appear in the display window.
44
Press STOP/MEMO. on the front panel.
A preset number will flash in the display window.
55
Press TUNING - or + on the front panel to select
the preset number you want.
66
Press STOP/MEMO. on the front panel again.
The station is stored.
77
Repeat steps 3 to 6 to store other stations.
To tune in a station with a weak signal
Press TUNING - or + repeatedly in step 3 to tune in the
station manually.
To clear all the stored stations
Press and hold STOP/MEMO. for about two seconds
and “CLEAR ALL” is appeared in the display window
and then press STOP/MEMO. again, the stations are
cleared.
If you have accidentally entered into the "CLEAR
ALL" mode and you do not wish to clear the memory,
do not press any key. After a few seconds, the
"CLEAR ALL" display will go off by itself and change
to normal mode.
Note
If all stations have already been entered, the FULL
message will appear in the display window for a
moment and then a preset number will flash.
To change the preset number, follow the steps 5-6 as
above.
Listening to the radio
Preset radio stations in the DVD/CD Receiver’s memory
first (see “Presetting radio stations” on the left).
11
Press FM/AM until AM (MW) or FM appears in
the display window.
The last received station is tuned in.
22
Press PRESET + or - repeatedly on the remote
control to select the preset station you want.
Each time you press the button, the DVD/CD Receiver
tunes in one preset station at a time.
33
Adjust the volume by rotating VOLUME on the
front panel or by pressing VOLUME + or - on the
remote control repeatedly.
To turn off the radio
Press POWER to turn the DVD/CD receiver off or select
another function mode (CD/DVD, AV1, etc.,).
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For manual tuning, press TUNING - or + on the front
panel repeatedly.
For automatic tuning, press and hold TUNING - or +
for about two seconds on the front panel.
To select a preset radio station directly
You can use the number buttons on the remote control
to select a preset radio station directly.
For example, to listen to preset station 4, press 4 on the
remote control. To listen to preset station 19, press 1
then 9 (within 3 seconds).
For your reference
If an FM program is noisy
Press MONO/ST. on the front panel so that
“STEREO” disappears in the display window. There
will be no stereo effect, but the reception will
improve. Press the button again to restore the stereo
effect.
To improve reception
Reorient the supplied antennas.