Filter
Top Products
19
Basic operations
Playback
Recording
Dubbing
Editing
Function setup
Others
Introduction
TYPE1/TYPE2 DVD-RAM disc with cartridge
Single sided
Turn the printed side up, and insert the cartridge
into the tray frame following the direction of the
arrow on the cartridge.
Double sided
Turn a desired recording/playback side up, and
insert the cartridge into the tray frame following the
direction of the arrow on the cartridge.
3 Close the disc tray.
Press the
button on the front panel or the
OPEN/CLOSE button on the remote control.
Notes
• Use the button on the front panel or the remote control to
open and close the disc tray. Do not push or hold the disc
tray while it is moving. Doing so may cause the recorder to
malfunction.
• Do not insert a disc which is unplayable, or any object
other than a playable disc.
• Do not apply downforce to the disc tray. Doing so may
cause the recorder to malfunction.
Turning the power off
Press the ON/STANDBY button on the front panel of
the recorder or the power button on the remote
control.
The “Unloading” icon appears at the top right corner of
the screen, and the ON/STANDBY indicator turns red,
then the power turns off.
Caution
• If the power fails or the power cord is disconnected from a
wall outlet while the recorder is in operation (ON/STANDBY
indicator lit in green), the HDD or a DVD-RAM disc may
become recording disabled on. In such a case, executing
an initialization of the disc using the formatting function of
the recorder may refresh them. However, all contents
stored on the disc will be completely erased by this
initialization process.
• This recorder may indicate alert messages with some discs
right after insertion. If such a disc is used for playback or
recording on other equipment, all data in the disc may be
damaged and the disc will not be played.
By executing an initialization of the disc using the
formatting function of the recorder, the disc will be able to
work.
• If the recorder freezes and does not respond at all, leave it
alone for about 15 minutes or longer. This may restore the
recorder. After the recorder has recovered, turn it off once
and turn it on again to use as usual. If the recorder is still
inoperable after more than 15 minutes have passed, press
and hold the ON/STANDBY button on the front panel for
about 10 seconds or longer. The recorder is forced to quit
and the power turns off. Turn the recorder on again and use
it as usual. (This 15-minute measure is available only when
“Screen Protector” is set to “On.” ( page 125))
Important: This is an emergency measure, which may
cause losses and/or damages of data. Avoid casual use of
this measure. If you try this while the recorder is working
properly, especially while the “Loading” or “Unloading” icon
is flashing, it may result in initializing of the HDD.
Note
• If there are any performance malfunctions of the HDD or
the DVD-RAM drive, immediately discontinue use of this
recorder, and disconnect the power cord from a wall outlet,
then contact your dealer. Continuous use of the recorder in
such a condition will aggravate the condition and result in
increased cost and cord repair time.
*RD-X2.Ope(US)p018-026 9/3/02, 11:23 AM19