Filter
Top Products
TORO GM 345 / 325-D Cutting Unit Drive
Notes
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
73
Troubleshooting
1. Poor cutting unit performance:
• Drive belt slipping.
• Tighten the drive belt.
• Adjust PTO belt tension spring to 3 3/16 in.(80.96 mm).
2. Drive belt failure:
• Improper belt alignment.
• Align drive belt.
NOTE: See the operators manual or the service manual for the complete adjustment procedure.