Filter
Top Products
58
(C8) (When the control input function is set to MUTE:)
C- IN01–
M
UT
E
Assign the function that mutes the input or output channel to the control input.
Closing the control input terminal mutes the set channel.
An input channel, when muted while in use, occupies the routed output, causing the Event-activated
broadcast by the input channel with lower priority not to go through to the same output channel.
Assigning a function to this terminal overwrites the previously set function on it if there is.
(C9) Channel number selection (MUTE)
C- IN01–
M
UTE IN
1
Using the Input channel or Output channel selection key, select the channel number to be muted.
One control input can mute one input or output channel.
IN1 – 8, OUT1 – 2,
Max. OUT8 when T-001Ts are used
(default: IN1)
Setting Range
(C10) Interlock output control setting (MUTE)
C- IN01–SYNC
O
FF
Perform ON/OFF setting for the function that closes the control output terminal in synchronization with the
control input terminal closure of the set number.
ON, OFF (default)
Setting Range
(C11) Interlock output terminal setting (MUTE)
C- IN01–C
O
UT01
This screen is displayed only when the interlock output control setting is set to ON.
Set the control output terminal which is closed in synchronization with the control input of the set number.
Assigning a function to this terminal overwrites the previously set function on it if there is.
(C12) (When the control input function is set to POWER:)
C- IN01– P
O
W
E
R
Assign the power ON/OFF function to the control input.
Power turns on when the control input terminal is closed, and turns off when the control input terminal is
opened.
Assigning a function to this terminal overwrites the previously set function on it if there is.
COUT01 – 04,
C-OUT01 – 12 when C-001T is used
(default: COUT01)
Note: When the interlock output control ON/OFF setting is ON.
Setting Range