Filter
Top Products
37
11.4.4. Utility setting items
CIN: Sets the functions to be assigned to the control input terminals. No function can be assigned to
the control input terminals set to "Event-Trigger."
COUT: Sets the functions to be assigned to the control output terminals.
POWER OFF: Sets whether or not to save data of the volume level set in normal operation mode when the
power is switched off.
RS232C: Sets the RS-232C communication speed.
MODULE: Displays or sets the module classification.
PRIORITY: Sets priority order when multiple inputs with the same priority are broadcast.
REMOTE: Sets the input and output channels for which the volume is remotely adjusted.
EVENT: Sets the Event that is activated when the unit's power is turned on.
VERSION: Displays the firmware version.
MEMORY: Initializes memory.
Function selection
UTILITY C-
I
N
Control input number selection and control input function setting
C- IN01– N
O
N
E
Use the Left and Right shift keys to move the setting items on the screen.
When the Down shift key is pressed with the control input function set to NONE and the cursor at the control
input number, the Event number assigned to that control input number can be confirmed. If no Event is
assigned to that control input number, the NONE indication is displayed.
C- IN01 EVENT N
O
NE
Event assignment display
When the displayed control input (C-IN01 in this example) is set to Trigger in the Event setting, the Event
number is displayed, making it impossible to assign the function on the utility screen. If the control input is not
set to Trigger, the Event number is not displayed.
(When the control input function is set to VOLUP:)
C- IN01– V
O
LU
P
(When the control input function is set to VOLDWN:)
C- IN01– V
O
LD
O
W
N
Assign the volume-up or volume-down function to the control input.
Closing the control input terminal increases or decreases the volume of the set input channel.
C- IN01– V
O
LUP IN
1
Channel number selection (VOLUP)
C- IN01– V
O
LD
W
N IN
1
Channel number selection (VOLDWN)
Using the Input channel or Output channel selection key, select the channel number for which you want to
change the volume.
[When the function is set to CIN:]