Filter
Top Products
8
Figure 8 Figure 9
Figure 10
11. CLOCK: Press and hold to set the hour fi rst. A beep will confi rm you are in the clock set
mode. Use the volume knob to select the hour (Figure 6) and then press the volume knob
in to set and cycle to the minutes (Figure 7). The hour determines AM or PM. Adjusting the
hour does not affect the minutes and vise-versa. Repeat this process to set the year, month
and the day (Figure 8, 9 and 10). Once set, press the Clock button briefl y to recall the date
and time whenever RDS or CD text is displayed. When the date is shown, only the month
and day will show (not the year).
12. VOLUME/TREBLE: Rotate clockwise to increase the volume or counter-clockwise to
decrease the volume. The volume level is represented in numbers from 0 (no output) to 30
(maximum output). If the volume ever sounds distorted, reduce the level immediately. Push
in and rotate counter-clockwise to reduce the treble or clockwise to increase the treble.
Press the volume knob in to set or the setting will store automatically and the display will
return to its previous state. This knob is also used to adjust and enter selections (by pushing
the knob in) when setting the Clock and Alarms. Adjusting the volume during Snooze will
cancel the Snooze mode.
13. AUDIO: Push to cycle through Stereo, SpacePhase
™
Wide mode, or Mono audio settings.
The SpacePhase Wide mode setting is designed to create a more expansive soundstage,
while the Mono setting reduces multiplex noise on weak FM stations, making otherwise
unlistenable stations listenable. Regardless of the previous audio setting, the SpacePhase
™
Wide mode will automatically engage each time the Music System is turned on.
EQ: This EQ differs from Audio in that it enhances lower frequencies primarily at lower
volume levels. We suggest the rear Bass level be set to the center detent position. Should
the bass ever sound distorted, immediately lower the bass level and/or volume. The Music
System is set at the factory with the EQ on. To temporarily turn the EQ off, press and hold
the Audio button. The display will show “EQ Off” and a confi rmation beep will sound. The
EQ will engage again automatically the next time the Music System is turned on. To keep
the EQ off, press and hold the Audio button and the display will show “EQ Always Off” and
a confi rmation beep will sound. The EQ will remain off until “EQ On” is selected. For more,
see the section marked “Getting the most from your Music System.”
Figure 11 Figure 12
14. DISPLAY: When in FM mode, press repeatedly to select between RDS Scrolling Text, (Figure
11), Static Text, or RDS Off. If a station is not broadcasting in RDS or the RDS signal is too