Filter
Top Products
13
• You may experience a delay in playback when inserting MP3 or WMA discs while the player
reads the directory.
• Paper labels stuck to CDR/CDRWs may become loose and possibly damage the player.
• CDs with severe scratches may not play properly.
• Do not insert anything except a CD inside the loading slot.
• In the rare event you experience an error, press and hold the Eject button to re-set the CD
mechanism and eject the CD. Failing that, unplug the power cord for 60 seconds and then
plug it back in.
Reception/RDS:
The internal FM antenna (built into the power cord) will provide good FM reception. The supplied
external FM antenna will usually provide improved reception. Fully extend the antenna and do
not bundle it with the power cord or other cords. Locating the antenna near a window or outside
wall will provide better reception than more interior locations. An outdoor antenna will provide the
best possible reception. Another alternative is to use an optional FM dipole antenna (adaptor
required). Connecting your cable television 75ohm coaxial cable to the external FM connection
may also provide clear local reception, although you must usually request activation of this service
through your cable company. Be sure to set the rear panel switch to “External” when using an
external FM antenna. Otherwise, it should remain in the “Internal” position. This switch has no
affect on AM reception. If a noisy FM station is received, setting the Audio button to “Mono” may
help to clear up some of the multiplex noise. Route the power cord away from the antenna for
best reception.
The Radio Data System (RDS) in the USA and Europe transmits text information along with audio
broadcasts. Program Service data will be shown in the upper right corner when available. Not all
FM stations utilize RDS, thus text data may not be present with some stations. For stations using
RDS, text may not appear or may appear scrambled if the signal is too weak. Experimenting
with the FM antenna location may improve RDS reception. RDS content is determined by each
individual FM station, therefore if any data is shown incorrectly, this is not a fault of the unit. There
are also limitations in terms of the kinds of characters that can be displayed. Therefore it is not
unusual to see a different character or blank space in cases where the precise character can't be
reproduced. Note RDS text will not be displayed in Sleep mode. RDS is not used on the AM band.
For AM, fold the included AM antenna’s integrated stand under the loop, (See Figure 11, page 10)
snap it in position, and connect the male stereo mini jack to the female mini connector on the
rear panel marked “AM Antenna”. Adjust for best reception for each AM station.
Buildings made with concrete, steel, or aluminum siding will hinder reception. Household
appliances, electric blankets, computers, and other electronic devices can also adversely affect
reception or inject noise. If you experience this, move the Music System further from the offending
device or plug it into an electrical outlet not shared by another device. Metal surfaces may hinder
AM reception.