Filter
Top Products
7
3. PRESETS 1– 6: Press and hold to memorize the tuned station to that particular preset.
A beep will sound confi rming the station has been successfully stored. Press briefl y to recall
the station associated with that preset. There are 6 FM presets and 6 AM presets. If a Preset
button is pressed but no station has been set, the display will show “Preset Empty” for
2 seconds. These buttons will also act as limited direct track access during CD playback.
The same station cannot be saved to more than 1 preset. Note the remote control’s 1
through 6 buttons cannot be used to save favorite stations to the presets, only recall them
after they have been saved using the Music System’s front panel buttons.
4. SOURCE: Press to cycle through the four sources: FM, AM, CD, and Auxiliary. The source
can’t be changed while the alarm is sounding. If the source is changed during CD playback
and the source is changed back to CD again, the CD will start playback from the fi rst track.
5. SLEEP: With the Music System playing FM, AM, CD, or an auxiliary device, press to begin
the 20 minute Sleep timer. The corresponding green LED will illuminate while the Sleep
timer is active and the display will countdown the remaining Sleep time. The Music System
will power off automatically at the end of the Sleep cycle. Sleep cannot be activated in CD
mode unless a CD is loaded. Note RDS and CD Text will not be displayed in Sleep mode.
6. / TUNE
+
/
-
: Press to advance to the next track on a disc or back to a previous track
if the track has been playing for under 10 seconds. If the track has been playing for more
than 10 seconds, pressing the button will re-start the currently playing track. When
listening to FM or AM, press briefl y to change the frequency up or down. Press, hold, and
release to seek for the next strongly received station. Press and hold to quickly advance
through the frequencies.
7. STOP: Press to stop CD playback and return to the fi rst track.
8. PLAY/PAUSE: With a CD loaded, press to initiate disc playback. Press during playback to
Pause playback and press again to resume playback. If the CD is paused for more than 5
consecutive minutes it will revert to Stop.
9. : Press to fast forward or fast reverse in approximately 10 second intervals. Press again
to resume normal playback or press Play. These functions are not on the remote control. Due
to the nature of MP3 CDs, using the fast reverse will cause the CD to stop playback once it
reaches the start of the track. Also note fast forward and fast reverse will not operate during
CD Intro mode. Pressing the fast scan buttons ( ) during shuffl e play may cause tracks
to repeat.
10. EJECT: Press to Eject a CD. The display will show “Ejecting”. This button is to eject only
and should NOT be used to load a CD. Always remove the disc in a straight position with-
out bending the disc. In the unlikely event you experience an error or a disc remains stuck
inside, press and hold the Eject button to re-set the CD mechanism and eject the CD.
Figure 6 Figure 7