Filter
Top Products
16
Operating your Receiver
Storing radio stations:
The receiver can store up to 40 radio stations in
memory. You can enter every single radio station
yourself or the receiver can store all available radio
station automatically in an ascending order.
Automatic preset storing
1. Select the band by pressing BAND on the main
unit or tuner on the remote control.
2- Press and hold BAND
on the main unit for 3
seconds. “MEMORY” will
be displayed in red and
will blink during the
automatic storing
process.
Radio frequencies will be scanned and radio station
stored automatically. When all available radio
stations are stored or if all 40 memory locations are
full, the auto preset will stop.
Manual preset
1. Select FM, MW or LW band by pressing BAND on
the main unit or tuner on the remote control
repeatedly.
2. Tune to the radio station to be stored. (see
"Manual tuning" on page 16 above for details)
3. Press and hold the MEMORY button on the front
panel or MEMO on the remote control. "MEMORY"
and a preset number will flash on the display.
4. Press TUNING UP/DOWN on the main unit or pr+ /
pr - on the remote control while
MEMORY is still flashing to select the desired preset
memory location.
5. Press the MEMORY button on the front panel or
the MEMO button on the remote control to store
frequency in selected preset location.
6. Repeat steps 1-5 to store other frequencies.
BAND TUNING MEMORY
SOURCE
NOTE
Weak signal can affect the "Automatic Preset
Storing function" efficiency. Adjust the antenna
for the best reception for more efficient search.
BAND TUNING MEMORY
SOURCE
BAND TUNING MEMORY
SOURCE
OPEN/CLOSE
BAND TUNING
OK
MEMORY SE
T
OPEN/CLOSE
BAND TUNING
OK
MEMORY