Filter
Top Products
Getting Started
EN
9
Te st Tone / Channel balance
Channel balance
Your receiver is equipped with a test signal generator
for balancing the channels. As the signal "travels"
from channel to channel, adjust the level controls
until each channel plays at the same loudness level.
Level adjustment & surround channel level
expectation
Even though you adjust the surround channel to be
as loud as the others on the test signal, you'll find
that on actual program material the surround chan-
nel is usually much lower than the front. Don't be
tempted to readjust the surround level; program pro-
ducers use surround mostly for subtle atmospheric
and ambience, and only rarely for special effects. A
good surround mix doesn't call attention to itself; if
it did, it would soon become distracting.
Using Headphones
To listen privately through your
audio system, use the PHONES jack
on the receiver. However, make
sure you turn down the volume
before you put on the head-
phones. Increase the volume to the
desired level after headphones are
in place.
Once headphones are connected, “HEADPHONE
DOWN MIX 2 CHANNEL” will scroll on display. This
feature automatically converts multi-channel speaker
outputs to 2 channel stereo for your listening pleas-
ure.
Hearing Comfort & Well-Being
• Do not play your headset at a high volume.
Hearing experts advise against continuous extended
play.
• If you experience a ringing in your ears, reduce
volume or discontinue use.
Factory Setting
The unit is preset to the following settings when you
first power the receiver up right out of the box:
Function = Tuner
Volume setting = 45
Bass & treble = 0 dB
Speaker settings: Center, rear, front = small
Subwoofer = on
EQ: FLAT
NOTE
The system is equipped with Dolby Digital,
and manufactured under License from Dolby
Laboratories.
Dolby Digital Manufactured
under license from Dolby
Laboratories. “Dolby”, “Pro
Logic II” and the double-D
symbol are trademarks of Dolby Laboratories.
Copyright 1992-1997 Dolby Laboratories, Inc. All
Rights Reserved.
NOTE
Reset to Factory Settings:
All preset radio stations and surround sound setting
will be lost after factory setting is restored. You may
restore factory setting with the following procedures:
1. Enter Standby mode
2. While holding down the SURR. MODE key, press
SOURCE UP.
3. All preset stations will reset to FM87.5MHz and all
receiver settings restore to default settings as
described above.
Courtesy Dolby Laboratories
Manufactured under License from
Digital Theater Systems, Inc. US Pat.
No. 5,451,942 and other world wide
patents issued and pending. “DTS
Digital Surround”, are trademarks of Digital
Theater Systems, Inc. copyright 1996 Digital
Theater Systems, Inc. All Rights Reserved.
]