Filter
Top Products
Operating your Receiver
Example 2:
Based on example 1, the VCR input is selected. If
SAT is selected, image and sound from the SAT
source will replace the VCR.
You can connect up to 8 audio/video sources to this
amplifier:
Source Corresponding connector
(receiver back panel)
- DVD DVD IN (audio / video)
- SAT SAT IN (audio / video)
- VCR VCR IN/OUT (audio / video)
- V-AUX V-AUX IN (audio / video)
- CD CD IN (audio only)
- TV TV IN (audio only)
- TAPE TAPE IN/OUT (audio only)
- TUNER built-in
- 6 CH 6 CH INPUT
When a source is selected, the arrow will point to the
source name on the display.
Example: Press DVD to select DVD as the source to
the amplifier.
Using the receiver to play a source
After having properly connected a source (DVD, CD,
VCR) to the receiver, you can partly control them
through the receiver.
Playing a DVD with the receiver
1. Connect a DVD player to the receiver (see con-
necting your receiver for details)
2. Press ON/ECO to enter Standby mode then press
SOURCE buttons on the front panel or ON/OFF
button on the remote control to switch on the
receiver
3. Select the DVD source.
4. Switch ON the DVD player and start playback
5. Switch ON your TV
6. Select the appropriate A/V channel on the TV
(refer to your TV manual for details) until the image
from the DVD player is displayed
7. Set the sound Mode if needed (see "Advanced
sound control" for details)
Example 1:
To play 5.1 Dolby Digital surround sound
Press SURR. MODE button until "Dolby Digital"
appears on the Display and all of the speaker'’
icons light up.
Example 2:
DVD: You may also need to select the Dolby Digital
5.1 on the DVD disc menu to have the digital sur-
round enabled providing that the disc is encoded
with Dolby Digital 5.1 (please refer to the DVD
player and DVD disc instruction)
Example 3:
LD: You may need to select a different Audio
Channel on your LD (refer to your LD player manu-
al)
8. Adjust volume knob accordingly
NOTE
1. Your receiver has a built in tuner. Just con-
nect the appropriate antenna on the back of
the receiver and you will be able to listen to
radio stations. (See details in Tuner section)
2. Other sources can be connected to the
above standard source. Example: you can con-
nect a LD into the DVD inputs.
3. Refer to the "Connecting To Audio-Visual
Components" section for details on connec-
tion.
NOTE
To play Dolby Digital or DTS sound, the source
must be connected to the receiver via the opti-
cal or coaxial terminal.
14
BAND TU
N
SOURCE
NOTE
Remote control selector must be on vcr/sat
to operate SAT features.