Filter
Top Products
Operating Your Receiver
EN
13
Switching on/off
• To enter Standby Mode, press the ON/ECO button
once.
• To power on the unit from Standby Mode, press
SOURCE or button on the main unit or
one of the source buttons on the remote control.
• To switch off the unit completely, press the
ON/ECO button or unplug the power cord from the
socket.
Show and Hide Control Panel
When the unit is powered on, touch the OPEN/ClOSE
button on the front panel of the unit to show the
control panel. Press again to hide the control panel.
Selection of Audio/Video source
When one of the audio/video source is selected, the
audio and video input corresponding to the name
will be activated.
The receiver acts as a switching device between all
the sources that are plugged into it.
Press SOURCE or on the main unit or one
of the source buttons on the remote control to access
the desired source.
Example 1:
If you connect a VCR player to the VCR input (audio
+ video) on the receiver and press the SOURCE
or button on the main unit until VCR1/ANL
shows on the display. You can also press vcr/V.AUX
on the remote to select the source directly. You will
be able to have the sound and image transmitted
by the VCR.
BAND T
U
SOURCE
BAND TUNI
SOURCE
BAND TU
N
SOURCE
NOTE
Remote control selector must be on hifi.
NOTE
Remote control selector must be on vcr/sat
to operate VCR player.
NOTE
The unit must be powered on before you can open
and close the control panel. Refer to “Switching
on/off” above for instructions on powering on the
unit.
ON/ECO
MUTE
OPEN/CLOSE
UNING
OK
MEMORY SETUP TEST TONE