Filter
Top Products
14 EN
GETTING STARTED
(cont.)
REC MODE – SP
LP
MENU Button
Lock Button
Power lamp
Recording Mode Setting
Set the tape recording mode depending on your
preference.
1
Set the Power Switch to “ ” while pressing down
the Lock Button located on the switch, then open
the LCD monitor fully or pull out the viewfinder
fully. The power lamp lights and the camcorder is
turned on.
2
Press MENU. The Menu Screen appears.
3
Press + or – to select “ CAMERA” and press SET/
SELECT. The CAMERA Menu appears.
4
Press + or – to select “REC MODE” and press SET/
SELECT. The Sub Menu appears. Select “SP” or “LP”
by pressing + or – and press SET/SELECT. Press + or
– to select “ RETURN”, and press SET/SELECT
twice. The Menu Screen closes.
•Audio Dubbing (੬ pg. 65) and Insert Editing
(੬ pg. 67) are impossible on a tape recorded in
the LP mode.
•“LP” (Long Play) is more economical, providing
1.5 times the recording time.
NOTES:
●
If the recording mode is switched during recording, the
playback picture will be blurred at the switching point.
●
It is recommended that tapes recorded in the LP mode
on this camcorder be played back on this camcorder.
●
During playback of a tape recorded on another
camcorder, blocks of noise may appear or there may
be momentary pauses in the sound.
Power Switch
Display
CAMERA Menu
Sub Menu
SET/SELECT Button
+, – Button