Filter
Top Products
Installation Summary
PHONECELL SX3e AMPS 5 USER MANUAL
Step 1. Choose an Antenna Location (pg. 6-7)
••
Choose a location.
••
Next, connect power to the
FWT and turn the unit ON.
••
Then, connect the antenna (not supplied).
••
Check the cellular signal strength and
move the antenna until you achieve the
best signal possible.
Step 2. Plug In Your Phone (page 8)
••
Once the antenna is connected, hook up
a phone.
••
Then, make a test call to check noise levels,
and adjust the antenna location accordingly.
••
NOTE: If your Phonecell SX3e is not pre-pro-
grammed for NAM (Number Assignment Module)
information, you’ll need to perform the
NAM/Phone Number Setup in Step 3. Then, return
to this step (2).
••
Plug in additional phones, Fax and/or Modem.
Step 3. NAM/Phone Number Setup (pg. 9-11)
••
If your Phonecell was not pre-programmed for
NAM information, you need to perform the
NAM/Phone Number Setup procedure.
••
Otherwise, continue to Step 4.
Step 4. Wall or Desk Installation (pg. 12-13)
••
After you’ve selected a location and made all
the necessary connections and adjustments,
your Phonecell SX3e is ready for either
wall-mounting or desktop/tabletop use.
There are four steps to installing the Phonecell SX3e FWT properly.
These steps are summarized below and explained in detail in the
remainder of this manual.