Filter
Top Products
PHONECELL SX3e AMPS 14 USER MANUAL
Phonecell Operation
LED Status Table
LED Color LED Activity Description
RED Flashing Malfunction. Hardware fault detected
RED Continuous No cellular service
YELLOW Continuous Moderate cellular signal strength, voice
YELLOW Flashing Moderate signal strength, fax /data
GREEN Continuous Best cellular signal strength, voice
GREEN Flashing Best signal strength, fax/data
RED/GREEN Flashing Diagnostic/programming mode
OFF None No Power
How to Use the LED Status Indicator
1) Plug in the AC power supply .
2) Wait approximately 10 seconds for the unit
to initialize.
3) Then, the LED indicator on the front of your
Phonecell will turn ON. The LED Status Table
below describes the modes and operation of
this 3-color indicator.
Once your Phonecell SX3 is installed and tested, it’s ready for operation.
LED Indicator
How to Place a Call
1) Pick up your telephone handset (your phone is now “off-hook”).
2) Listen for dial tone (If service is not available, a No-Service tone is
produced. Hang-up the phone and try again.)
3) Dial the phone number.
How to Receive a Call
••
When your telephone rings, pick up the handset and begin talking.
How to End a Call
••
Hang-up the phone (place the handset back onto the telephone cradle).
The Hookflash Function
When you initiate the Hookflash function, it automatically lets you:
••
Speed up the connection after you dial a phone number.
••
Answer an incoming call that occurs when you’re dialing a phone number.
••
Use special (supplementary) cellular services which may be available
in your cellular service area (see Special Cellular Services on page 16).
How to Use the Hookflash Function
Depending upon your phone, there are two ways to initiate the Hookflash function:
••
Press the dedicated “HOOKFLASH” or “FLASH” key on your telephone.
••
Press the hang-up or switch-hook mechanism on your phone once quickly
(approximately
1
/2-second).