Filter
Top Products
Pre-Walk-Thru Checklist
Following the instructions fully to this point you
have successfully completed the following check-
list:
❒
Located the base station properly.
❒
Connected power to base station transceiver.
❒
Connected the 1/2-wave antennas to the base
station. Check frequency range of the antenna
with the frequency of the base station by cor-
rectly matching color codes.
❒
For a large system in which a split-
ter/combiner (SC-600) is used, make sure the
antenna cables are connected to the correct
ports and that the main antennas are con-
nected to the marked SC-600 ports.
❒
Set RF transmit and receive switches on the
base stations(s) to match their respective
beltpacks.
❒
Set transmit mode switch on base station.
❒
Set wired intercom type correctly.
❒
Set audio channel correctly.
❒
Set Telex switch properly.
❒
Set Code Switch to a unique code that
matches the beltpack. (BTR-600C only)
❒
Connected headsets to base stations (if
needed) and all beltpacks.
❒
Connected the base station to any auxiliary
audio, intercom, or external speaker if
needed.
❒
Installed batteries in the beltpack.
❒
If you missed any of the above instructions,
go back and complete that instruction before
going on.
-20-