Filter
Top Products
7
REMOVING THE PACKING FROM THE CD PLAYER
Before connecting power to your audio system, the protective
packing should removed from the CD compartment.
To remove the protective packing:
Open the CD compartment by pressing down on the •
OPEN/CLOSE area marked at the front corner of the CD
lid.
The lid will open.
Remove any cardboard protective packing from the CD •
compartment.
Close the CD lid.•
DAB/FM RADIO AERIAL
Before using your radio for DAB or FM reception, unwrap
and fully extend the aerial wire. You may need to adjust the
position of the aerial wire for maximum signal strength.
CONNECTING POWER
Check that the mains voltage marked on the rating plate •
under the unit is the same as the voltage in your area.
Plug the AC power cord into the AC inlet•
Plug the mains plug into the wall socket and switch the •
mains power on.
ADJUSTING THE VOLUME
Automatic clock setting:
The clock time will set automatically when a DAB station is
rst tuned.
In areas where DAB reception is not available, manual clock
setting will be necessary.
To set the clock manually:
With the system set to Standby, press and hold the • CLOCK
ADJ./PROGRAM button on the remote control.
The display will show the legend ‘24 HOUR’ with the digits 24
ashing.
NOTE: The display will not light during clock setting.
Press the • { or } buttons to select 24 hour or 12 hour
mode for the clock.
Press the • CLOCK ADJ./PROGRAM button.
The display will show the time currently set with the hours
digits ashing.
Press the • { or } buttons to set the hours digits to the
correct time.
Press the • CLOCK ADJ./PROGRAM button.
The display will show the time currently set with the minutes
digits ashing.
Press the • { or } buttons to set the minutes digits to
the correct time.
Press the • CLOCK ADJ./PROGRAM button.
The clock settings will be stored.
GETTING STARTED
STANDBY CONTROL
To turn the system on:
Touch the • touchpad or press the /STANDBY button
on the remote control.
The display will light and the system will set to play the last
function used. If this was radio, the last station played will be
selected.
To turn the system o:
Touch the • touchpad or press the /STANDBY button
on the remote control.
The system and display light will switch o. The clock will
continue to run whilst mains power is connected.
STANDBY CONTROL SETTING THE CLOCK
VOLUME CONTROL
To increase the volume:
Touch the • VOLUME M touchpad or press the VOLUME
+ button on the remote control.
To decrease the volume:
Touch the • VOLUME N touchpad or press the VOLUME -
button on the remote control.
MUTE
The Mute function will set the volume to minimum.
To mute the volume:
Press the • MUTE button on the remote control to set
mute at any time.
Press the • MUTE button again to restore the volume to its
previous setting.