Filter
Top Products
16
iPod ADAPTORS SELECTING AN ADAPTOR
Before docking your iPod you must rst check if your iPod
has a docking connector. Early iPod models do not have one
and cannot be docked to your unit. The docking connector is
located on the base of the iPod as shown below.
If you don’t have a dock adaptor
If your iPod was not supplied with a standard dock adaptor,
or if you have lost the adaptor, you can buy one from Apple
on-line. To determine the exact model of your iPod, refer to
this web-link - http://support.apple.com/kb/HT1353. You
can then browse the iPod accessories page on the Apple
website to nd an adaptor for your iPod model that can be
purchased on-line.
To connect your iPod via the AUX IN jack:
Using a 3.5mm stereo jack cable (not supplied), connect •
one end of the cable to the headphone socket of the iPod,
and the other end to the AUX IN jack on the front panel.
Before docking your iPod, you must t the correct iPod
adaptor to the docking bay. Each iPod adaptor matches the
shape of a particular iPod and is necessary to ensure that
your iPod is securely held when docked.
CONNECTING OTHER iPod
MODELS (INC SHUFFLE)
To listen to your iPod, follow the instructions on page 15 •
for playing equipment connected to the AUX IN jack.
NOTE:- The volume control of the iPod must be turned up
when playing through the AUX IN jack.
NOTE:- An iPod connected to the AUX IN jack cannot be
operated from the remote control.
Headphone jack
To AUX in
Docking Connector
iPod adaptor
Docking bay
FITTING THE iPod ADAPTOR
When your iPod was new it may have been supplied with a
standard dock adaptor in the packaging. If so, t the adaptor
by pressing it gently into the Docking Bay as shown above.
NOTE: Do not dock an iPod without tting the correct adaptor,
you may damage the iPod and your unit.