Filter
Top Products
6
DAB/FM RADIO AERIAL
Before using your radio for DAB or FM reception, unwrap
and fully extend the aerial wire. You may need to adjust the
position of the aerial wire for maximum signal strength.
CONNECTING POWER
Check that the mains voltage marked on the rating plate •
on the back of the unit is the same as the voltage in your
area.
Remove any protective packing from the mains plug •
pins.
Plug the mains plug into the wall socket and switch the •
mains power on.
MAINS POWER SWITCH
There is a mains power switch located under the unit. Check
that this is set to the ON position.
ADJUSTING THE VOLUME
Automatic clock setting:
The clock time will set automatically when a DAB station is
rst tuned.
Manual clock setting:
The clock can also be set manually if you live in an area where
it is not possible to receive DAB broadcasts.
Check that the system is set to Standby.•
Press and • hold the ID3/MEM./C ADJ. button.
The hours digits will ash.
Press the • } or { button to set the hour digits.
Press the • ID3/MEM./C ADJ. button.
The minutes digits will ash.
Press the • } or { button to set the minutes digits.
Press the • ID3/MEM./C ADJ. button.
The clock time will be set and the unit will return to Standby
mode.
NOTE: When a DAB station is tuned, the clock will always be
set automatically.
GETTING STARTED
STANDBY CONTROL
To turn the system on:
Press the • STANDBY/ON button.
The display will light and the system will set to play the last
function used.
To turn the system o:
Press the • STANDBY/ON button.
The system will switch o and the display light will dim. The
clock will continue to run whilst mains power is connected.
STANDBY CONTROL SETTING THE CLOCK
VOLUME CONTROL
To increase the volume:
Press the • VOLUME + button.
To decrease the volume:
Press the • VOLUME - button.
The volume level will be displayed on a scale from 0 to MAX (40).
MUTE
You can use the Mute function to instantly set the volume
to minimum.
To mute the volume:
Press the • MUTE button on the remote control to set mute
at any time.
Press the • MUTE button again to restore the volume to its
previous setting.
In normal use this may be left in the ON position. When the
unit is to be unattended for an extended period (for example,
holidays) set the mains power switch to the OFF position or
disconnect the system from the mains.
Power cableMains power switch
UNDERSIDE VIEW