Filter
Top Products
3
PREPARATION FOR USE
PROTECTIVE FILM
Some of the panels on this unit are protected by plastic lm
for protection in shipping. Remove all of this lm and any
tape securing it before use.
NOTE: Damage may result if lm or tape is left in place on the
sliding front panel and power is connected to the unit.
PLACEMENT
Placement on a table or shelf:
Place the unit on a sturdy table or shelf where it cannot get
knocked over and where there is a clear line of sight to the
remote handset.
Make sure that there is a clearance of 10cm (4 inches) above
the unit for ventilation.
Optional wall-mounting:
The MC-121IDAB system has back panel xings for optional
wall-mounting.
If you plan to wall-mount the system, you will need to x two
screws into the wall.
Before xing the screws, plan the location carefully, ensuring
that mains power is accessible.
Once you have planned the location, x two screws (not
supplied) into the wall to support the main unit, spaced by
240mm. Before mounting the screws, check the t of the
heads in the back panel keyhole slots to ensure that the
screw heads will not pull out of the slots.
240 mm
Use a spirit level to ensure that the screws will be level and
check that the unit will be xed at the height you require.
When you have mounted the screws, mount the unit
carefully onto the screw heads. Check that the mounting is
secure before use.
NOTE:- Most walls will require the use of wall-plugs when
mounting the xing screws. If you are in any doubt concerning
the type of xing required or the security of wall-mountings,
consult a building professional.
Important notes for wall-mounting:
Tesco accepts no liability for damages caused by incorrect •
assembly, installation or improper use.
Ensure that the wall has sucient strength to hold the •
weight of the system.
If there is any doubt regarding the condition or the load •
bearing of the wall, please consult a specialist from the
building trade.
The wall xings used must be suitable for the type of wall •
(materials, thickness, condition), so that the maximum
load bearing of the wall can be guaranteed.
Ensure that no electrical cables, water pipes or gas pipes •
are located within the wall.
Before mounting, check the location of the nearest •
mains socket.
Wear safety g• oggles when drilling.
Keep small parts out of reach from children.•