33
Recording operations
RQT5355
1
2
2
3
B
23
A
@
21
H
REC
PAUSE
@
DECK 1/2
TAPE EDIT
ÎNR2 REC
1
2
2 REC1
»
A
Recording the radio
Preparation: Do the preparatory steps (➡ page 31).
1 Tune to the required station.
(➡ page 16 or 17)
2 Press [´ REC PAUSE].
The deck goes into the recording standby mode and the play
indicator “"” or “!” starts flashing.
3 Press ["] (reverse side) or [!] (forward side) to
start recording.
To stop recording
Press [º].
To temporarily stop recording
Press [´ REC PAUSE].
The deck goes into recording standby mode.
To resume recording press ["] or [!] with the flashing indicator.
»
B
Tape-to-tape recording
Preparation: Do the preparatory steps 1 and 3 (➡ page 31).
1 Set the tape direction on both decks.
1 Press [DECK 1/2] to select “DECK 2”.
2 First press ["] or [!], and then [º].
Repeat steps 1 and 2 for deck 1.
2 Press [TAPE EDIT] to start recording.
The indicator “"” or “!” shows deck 2 direction.
If either deck 1 or deck 2 stops, the other deck also stops.
To stop recording
Press [º].
Both decks will stop.
To enjoy another source while recording
Start playing the other sound source.
You can change the volume level and tone quality without affecting
the recording.
Note
The recording level and the noise reduction effect of the original
(playback) tape will be recorded on the new tape.