11
Before use
RQT5355
»
A
Setting the time
This is a 24-hour clock.
The example shows how to set the clock for 16:25 (4:25 p.m.).
1 Press [ê/I] to turn the unit on.
2 1 Press [CLOCK/TIMER, –DEMO] to
display “CLOCK”.
Each time you press the button:
CLOCK>FPLAY>FREC>Original display
^-------------------------------------------------------------------}
2 Within 7 seconds
Press [SET].
3 1 Press [TUNING (X or W)] to set the
time.
The time display can be changed in one minute units by
tapping the buttons, and quickly by holding down the but-
tons.
2 Press [SET].
The time is set and the original display is restored.
Displaying the clock
Press [CLOCK/TIMER, –DEMO].
The clock is shown for about 5 seconds.
»
B
Turning DEMO off
A demonstration of the display is shown if you have not set the clock.
Turn DEMO off to get the most from ECO mode.
While the unit is on:
Press and hold [CLOCK/TIMER, –DEMO]
until “NO DEMO” is displayed.
Each time you press and hold the button:
NO DEMO (off)bDEMO (on)
»
C
Saving power in the standby
mode
Set the unit to reduce energy consumption in the standby mode
(11 W>0.5 W).
While the unit is on:
1 Press [MODE].
The current mode is displayed.
2 Within 5 seconds
Press [MODE] to display “ECO”.
Each time you press the button:
NORMAL (off)bECO (on)
ECO: The clock is not displayed in the standby mode. The “ê” and
“FPLAY/FREC” indicators still light.
Note
The mode can be switched to ECO when the unit is in standby but it
cannot be switched back to NORMAL.
A
1
2
1
2
3
B
C
1 2 32
1
1
2
1
2
MODE
CLOCK/TIMER
@
DEMO
SET
CLOCK/TIMER
@
DEMO
SET
MODE
?
TUNING
@
H/I